Mil Spec Fasteners Fastening Products of Lancaster, Inc. has successfully provided the United States Armed Forces with quality MIL-Spec fasteners since 1991. Air Force Major (Retired) Robert Welk, Owner of Fastening Products, also holds two Engineering Degrees from Carnegie-Tech College. This highly specific and technical Division supplies a variety of internally and externally threaded products and maintains an excellent quality and on-time delivery record. Fastening Products also specializes in non-threaded MIL-Spec fasteners such as washers, pins and nails. We are proud to have our fasteners on U.S. submarines, battleships, tanks and firearms throughout the world. Quality Control IN-HOUSE QUALITY CONTROL PROGRAM MIL-45208 quality control procedures approved and certified by the following government agencies: Defense Supply Center Philadelphia (DSCP); Defense Contract Management Command (DCMC); General Services Administration (GSA); Federal Prison Industries (UNICOR); Various bases and prime military contractors. IN-HOUSE MEASURING AND TESTING EQUIPMENT CALIBRATIONS PROGRAM MIL-STD 45662 calibrations procedures approved and certified by the above agencies. TESTING PROCEDURES When required by customer, inspection is performed in accordance with Mil-STD 105E, QAP EQ001, or to customer requirements. Also, if required, physical and chemical properties are tested by a certified fastener testing lab to assure conformity with all requirements. FULL TEST REPORTS AVAILABLE When requested at time of order, full chemical, physical and dimensional test reports and certifications are supplied with the products.